Forum
Ansteuerung eines Magnetventils (Elektronik)
» Hallo,
»
» ich möchte ein Magnetventil über ein mobiles gerät ansteuern es hat im
» Datenblatt folgende elektrische Daten:
»
» Coil Impedance:
» 3.0 Ω PWM Driven
»
» Operating Voltage:
» NOT to be controlled by constant voltage. Coil must be driven by a
» controlled current or a PWM current. PWM function is practical above 7
» Volts.
»
» Operating Current:
» Opening Current: 2.0  0.2 Amps @ 875 bar
» Holding Current: 0.9  0.1 Amps
»
» Spannungsquelle für die Ansteuerung soll ein 12v Akku mit realen 13v
» (Kfz-Batterie) werden.
»
» Komme auf einen Widerstand mit ca. 11,5 Ohm und 11 W für den Haltestrom und
» 5 Ohm und 5 W zum ansteuern.
»
» Kann mir das jemand bestätigen (Ventil sehr teuer) oder widerlegen (mit
» Daten und Fakten).
»
» Schon mal danke im voraus.
Du schreibst ja selbst :
» NOT to be controlled by constant voltage. Coil must be driven by a
» controlled current or a PWM current. PWM function is practical above 7
» Volts.
also wird das mit einem Vorwiderstand an 12 V nicht klappen.
Gesamter Thread: