Forum
Sensoren für Arduino (Bauelemente)
» Egal wie, was du verwenden willst, du musst das Signal gleichrichten und
» als Spannung ausgeben.
Bei den mittlerweile üblichen Beschleunigungssensoren alles On-Die, Schnittstelle dann I2C o.ä.
Gesamter Thread:
Welches Bauteil als Klopf-Sensor (für Schalter) - AndreI, 01.09.2015, 13:08 (Bauelemente)
Welches Bauteil als Klopf-Sensor (für Schalter) - Maik., 01.09.2015, 13:15
Welches Bauteil als Klopf-Sensor (für Schalter) - AndreI, 01.09.2015, 13:23
Klatschschalter mit Mikrofon - geralds, 01.09.2015, 13:41
Klatschschalter mit Mikrofon - AndreI, 01.09.2015, 13:51
Sensoren für Arduino - geralds, 01.09.2015, 14:49
Sensoren für Arduino - xy, 01.09.2015, 16:44
Welches Bauteil als Klopf-Sensor (für Schalter) - xy, 01.09.2015, 14:22
Welches Bauteil als Klopf-Sensor (für Schalter) - AndreI, 01.09.2015, 14:43
Welches Bauteil als Klopf-Sensor (für Schalter) - xy, 01.09.2015, 16:41
Welches Bauteil als Klopf-Sensor (für Schalter) - olit, 01.09.2015, 15:08
Welches Bauteil als Klopf-Sensor (für Schalter) - AndreI, 01.09.2015, 15:57